| 1)
Slide the Back Nut (BN), Rear Washer (RW) and Grommet (GR) onto the
cable and strip the cable to the dimensions as shown, taking care not to
nick the centre conductor or braid. Fold back the braid(s)
and slide the Top Hat (TH) onto the cable so that the tube of the Top
Hat is between the dielectric and the braid (under the cable jacket).
Trim off the surplus braid. Tin the centre conductor. |
| 2)
Slide the Insulator (I) over the centre conductor to butt against the
Top Hat. Slide the Pin (PI) onto the centre conductor so that the flange
on the Pin butts against the Insulator. Solder the Pin.
Slide the rubber Grommet and Back Nut up to the Top Hat, trapping the
braid. |
| 3) Insert the cable into the body as far as possible and engage the threads of the Back Nut. Tighten the Back Nut. |
