| 1)
Slide the Back Nut (BN), Rear Washer (RW) and Grommet (GR) on to the
cable and strip the cable to the dimensions as shown, taking care not to
nick the centre conductor or braid. Fold back the braid and slide the
Top Hat (TH) onto
the cable so that the tube of the Top Hat is between the dielectric
and the braid (under the cable jacket). Trim off the surplus braid. Tin
the centre conductor. |
| 2)
Slide the Rear Insulator (RI) over the dielectric to butt against the
Top Hat. Slide the Contact (CT) onto the centre conductor so that the
flange on the Contact butts against the Rear Insulator. Solder the
Contact.
Slide the rubber Grommet and Back Nut up to the Top Hat, trapping the
braid. Slide the Front Insulator (FI) onto the Contact until it butts
against the Rear Insulator. |
| 3) Insert the cable into the body as far as possible and engage the threads of the Back Nut. Tighten the Back Nut. |
