Page d'Accueil

Qui sommes nous?

Contact

Part Number: BN02-0174-L06-2

Details & Specifications

Description BNC Clamp Bulkhead Jack, Compression Fixing To Fit Cable Types RG174, RG188, RG316, LBC100 Fixing Method Clamp Body Brass, Nickel Plated Contact Brass, Gold Plated Dielectric PTFE Backnut Brass, Nickel Plated Gasket Rubber Insulator PTFE O Ring Rubber Top Hat Brass, Nickel Plated Washer Brass, Nickel Plated Cable Retention Equal to breaking strain of cable Durability 500 mating cycles Impedance 50 ohms Max. Frequency 4 GHz Temperature Range -55 to +85 degrees C Working Voltage 500 Volts RMS Maximum

Panel Fixing Information

Cut-out Dimensions A=12.00mm, B=12.90mm

Assembly Instructions

Strip Dimensions A=7mm, B=2mm, C=4mm 1) Slide the Back Nut (BN), Rear Washer (RW) and Grommet (GR) onto the cable and strip the cable to the dimensions as shown, taking care not to nick the centre conductor or braid. Fold back the braid(s) and slide the Top Hat (TH) onto the cable so that the tube of the Top Hat is between the dielectric and the braid (under the cable jacket). Trim off the surplus braid. Tin the centre conductor. 2) Slide the Rear Insulator (RI) over the dielectric to butt against the Top Hat. Slide the Contact (CT) onto the centre conductor so that the flange on the Contact butts against the Rear Insulator. Solder the Contact. Slide the rubber Grommet and Back Nut up to the Top Hat, trapping the braid. Slide the Front Insulator (FI) onto the Contact until it butts against the Rear Insulator. 3) Insert the cable into the body as far as possible and engage the threads of the Back Nut. Tighten the Back Nut.